SiriusXM XDNX1V1 User's Guide download pdf (Page 28)

Sedan/Coupe With Antenna Placed at the Rear of the Roof:

1 Feed the antenna cable from the antenna underneath the rubber

molding around the rear window. Use a blunt plastic putty knife or

similar blunt tool to lift the rubber molding around the rear window

and tuck the antenna cable underneath the molding. Route the

antenna cable around and down the window to the lowest point. If

your rear window does not have rubber molding, we recommend

consulting a professional installer.

2 Route the antenna cable out of the window molding and into the

rubber weather stripping around the trunk opening. Lift the weather

stripping from the opening and tuck the cable inside it, then replace

the weather stripping. To avoid sharp bends in the cable, run the

cable inside the weather stripping for a few inches, then remove the

cable from the weather stripping inside the trunk. Keep the cable

away from hinges, gears, etc., that could damage it.

3 Route the cable out from the rubber weather stripping and along the

trunk wall. Continue routing the cable into the vehicle cabin through

a conduit or along an existing wiring harness.

4 Route the cable through the

main cabin area under the

interior trim, towards the front

of the vehicle. Use a blunt

plastic putty knife or similar

blunt tool to lift the plastic

trim just enough to tuck the

cable under underneath.

Avoid side airbag locations

on back pillars and above the

doors. Airbag locations are

Vehicle Installation

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 93 94

No comments

SiriusXM XDNX1V1 User's Guide Page 28