SiriusXM XDNX1V1 User's Guide download pdf (Page 31)

plastic trim just enough to tuck the cable under underneath. Avoid

side airbag locations on back pillars and above the doors. Airbag

locations are marked with “SRS” logos. Be careful not to crimp or cut

the cable.

3 Bring the cable out from the trim near the front of the cabin and

route it under the carpet toward the dashboard or console. Coil any

excess cable in a hidden location, such as under the carpet, keeping

it away from any vehicle pedals or controls. Secure the excess cable

with wire ties (purchased separately).

4 Bring the end of the cable out at the PowerConnect Vehicle Dock

location. Leave yourself enough cable so you can easily connect it to

the antenna connector of the dock.

5 Continue with “Step 5: Connect the Magnetic Mount Antenna and

PowerConnect Power Adapter” on page 34.

Convertible

1 Bring the antenna cable from the antenna into the trunk at the front

edge of the trunk lid. Keep any bends in the cable loose. Tape or tie

the cable along the inside of the

trunk lid to the trunk lid hinge strut.

2 Allow enough slack in the cable so

the trunk lid can easily open and

close and keep the cable away from

hinges, gears, etc., that could crimp

or cut it. Route the cable along the

trunk wall and into the cabin through

a conduit or along an existing wiring

harness.

Vehicle Installation

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

No comments

SiriusXM XDNX1V1 User's Guide Page 31